OHSAS18000认证资料：弱电工安全作业规程

OHSAS18000 certification information: weak electrical safety operation rules

1检修及维护人员要熟悉所用设备的性能、原理，不要随意拆修电器设备。使用喷灯应遵守喷灯安全操作规程。

1 overhaul and maintenance personnel should be familiar with the equipment performance, principle, do not arbitrarily repairing electrical equipment. Using a blowtorch blowtorch should comply with the rules for safe operation.

2维修人员应做好值班监视工作，经常巡视各种机件动作是否正常，定期测试，定期检查。

2 repair personnel should be on duty to supervise the work, often visited the various mechanical movement is normal, regular test, periodic inspection.

3经常保持机房和机件设备的清洁。

3 keep the room and mechanical equipment cleaning.

4进行高空作业时，严格遵守高空作业安全操作规程。

4 for high-altitude operations, strictly abide by the safety rules.

5在处理线路故障时，要注意弱电与强电交叉接触。如辨别不清时，应行先验电。

5 in processing line failure, should pay attention to weak and strong cross contact. Such as confused, be a priori power.

6总机电话间、机件室、电力室等严禁明火作业。易燃物品必须妥善保管。用汽油或酒精擦洗设备时，必须加入70%的四氯化碳。清洗时应戴上防毒面具。

6 telephone switchboard, machine room, electrical room fire operation is strictly prohibited. Flammable items must be properly kept. Gasoline or alcohol scrubbing equipment, must add 70% carbon tetrachloride. Cleaning should be wearing a gas mask.

7充电时应按充电工安全操作规程进行。

The 7 charging should be based on the charging work safety operation procedure.

8.

8

8高压配电运行规程

8 high voltage power distribution operation regulations

A. 配电装置加入运行前应进行下列检查：

A power distribution unit into operation should be performed before the examination:

1所有瓷瓶清洁无裂纹，门窗上防鼠网栏是否完好；

1 all porcelain clean and no crack, the doors and windows on the rat guard net bar is intact;

2母线清洁无杂物，接触良好，漆色鲜明。测定母线电阻：每一千伏不低于1兆欧；

2 bus clean without debris, the contact is good, bright color. Determination of the resistance of each bus: one thousand volts of not less than 1000000000000 ohm;

3油开关，油面应在标准位置，油色透遵无杂质，油标玻璃管及油箱外部清洁无漏油。各部接线螺丝应紧固，不松动。各部瓷瓶无裂纹，操作机构各部销子无断裂或脱离，跳闸弹簧无断裂，缓冲器油量充足。电力、操作回路熔断器符合规定值；合、拉闸试验合格；

3 oil switch, oil surface should be at the standard position, color transparent with no impurities, oil standard glass tube and the external fuel tank cleaning oil leakage. The wiring screws should be fastened, do not loose. The Department of porcelain insulator without crack, operation mechanism of each pin no breaks or detachment, tripping spring fracture, buffer oil sufficient quantity. Power, control circuit fuse with the specified value; and, pulling test;

4隔离开关触头应接触严密。瓷瓶和连接拉杆无断裂，销子无脱落，电锁销子在正确位置；

4 isolating switch contact should be tightly contacted. Porcelain insulator and the connecting rod without fracture, the pin off, lock pin in the correct position;

5互感器的母线、二次线路及接地线，应联接牢固、完好不松动。测定绝缘电阻：一次侧每1千伏不低于1兆欧。二次侧应接地良好。电压互感器一、二次熔断器完整，二次回路无短路。油标指示应正确，不漏油。矽胶为蓝色颗粒状。电流互感器二次回路无断线；放电间隙完好；

5 transformer bus, two line and ground line, should firm connection, good not loose. Determination of insulation resistance: a side every 1000 volts of not less than 1000000000000 euro. Two side should be grounded in good. Voltage transformer one or two fuses complete, two circuit without short circuit. Oil standard instructions should be correct, no oil leakage. Silica gel blue granular. The current transformer two loop without disconnection; discharge gap in good condition;

6避雷器的瓷套管应清洁无裂纹。接线及接地线完整良好，并记录指示器的指示数据；

6 arrester porcelain bushing shell should be clean and no crack. Wiring and grounding the integrity of good, and record the pointer data;

7电力电缆头应无漏油，外表清洁，接地线接触良好，室内电缆外部涂漆良好，钢铠不生锈，不断裂；

7 power cable head should be no leakage, clean appearance, grounding contact is good, indoor cable external painting is good, steel armor does not rust, does not break;

8电力电容器的外壳应无膨胀漏油，绝缘子完整良好，熔丝完整。

8 power capacitor shell should be no expansion of oil leakage, good insulator intact intact, fuse.

B. 正常运行中的巡视规定：

The B. In the normal operation of the inspection regulations: